Spring Four Buckles, Bumpers And Mushroom Nails Installation Method

Spring Four Buckles, Bumpers And Mushroom Nails Installation Method

Spring Four Buckles, Bumpers And Mushroom Nails 

1、[spring four buckle installation tutorial]
The tools/materials needed are: rubber backing plate, installation hammer, round punch, snap button installation tool and base

The required leather, a set of snap buttons
First mark the leather surface with an awl, and punch holes in the leather surface with a round punch of appropriate size
AB side installation
In order to prevent the face buckle from being scratched, the conventional method is to put a piece of white paper/tissue between the installation base and the face buckle
Choose a snap button installation tool of the right size, whose protruding end can pass through the pogo pin, and tap the installation tool with an installation hammer until the button can be fixed
CD surface installation Place the D buckle on the installation base
The C buckle is embedded on the D buckle. Use the concave end of the four-in-one buckle installation tool of the appropriate size to fit on the C buckle, so that it can just fit the C buckle.
Hit with a mounting hammer
The installation is complete

 

2. [Tutorial for rivet installation]

Preparation tools: rivet, hammer, round punch, mounting table, ram, cutting board pad

Punch holes in the leather with a round punch of the same diameter and size as the foot of the rivet

Press the leather onto the underside of the rivet

Put the rivet cover on the rivet foot

Move the leather to the small hole on the mounting table that has the same diameter as the bottom surface of the rivet, and then use the ram to align the rivet cover

Hit the striker to make the cover and foot more stable

The installation is complete

 

3. [Mushroom nail installation tool]

Preparation tools: mushroom nails, leather, hammer, round punch, ram, mounting table, cutting board mat

Punch holes in the leather with a round punch of the same diameter and size as the bottom of the mushroom nail

The diameter of the mushroom nail cover is 10mm, so a 10mm rod should be selected accordingly

Press the leather onto the bottom of the mushroom nail

Put the cover of the mushroom nail on the foot of the mushroom nail

Move the leather to the small hole on the installation platform that is consistent with the diameter of the bottom surface of the mushroom nail

Align the ram with the mushroom nail cover

Hit the striker to make the cover and foot more stable

The installation is complete

Вернуться к блогу