Oblong Punch Tools Set Leather Belt Hole Puncher Oval Hole Watch Band Flat Punches|WUTA

Description

Brand: WUTA
Name: Black Oblong hole punch
6 Sets:
Set A-3 Pcs: Commonly used oblong punch set for leather goods
Set B-5 Pcs: Commonly used oblong punch set for belts
Set C-6 Pcs: Commonly used oblong punch set for watchband straps
Set D-5 Pcs: Essential set for belt punching
Set E-7 Pcs: Commonly used set for belt punching
Set F-7pcs: Commonly used set for watchband straps
Use Application: Punching holes in belt/watch band/leathercraft
Package: 1 Set, the size depends on your choice.

Features

1 . High-temperature treatment process, with better toughness & hardness. The edge is polished by hand, easy to make leather holes. And this is a basic punch tool, fit for leather crafters. If you have high-quality requirements, please choose our senior series leather punch.

2. The whole body with black electroplating on the surface, with strong anti-rust performance and wear resistance, is sturdy, provides a comfortable hand feeling, suitable for intensive stamping and long-term leatherworking craft.

3. A clear size mark, easy to find the correct size.

4. Original and practical design, wide discharge port, the punching is smoother, not easy to block, leather can come out easily.

5. 6 Sets available
Set A-3 Pcs: Commonly used oblong punch set for leather goods
Set B-5 Pcs: Commonly used oblong punch set for belts
Set C-6 Pcs: Commonly used oblong punch set for watchband straps
Set D-5 Pc s: Essential set for belt punching
Set E-7 Pc s: Commonly used set for belt punching
Set F-7 Pcs: Commonly used set for watchband straps. It
can be used to make clean oval shapes in leather, belts, straps, gaskets, clothes, rubber, and other soft materials.

Use Notice:

1. Perpendicular to the leather surface, tap it lightly, and then force it until it penetrates 0.5-1mm. If the leather doesn't penetrate, keep hitting until it penetrates. The size is more than 5*10mm, because the cutting area is relatively large, it needs to be tapped a few more times.

2. The blade of our small-sized punches will be made thinner, and the leather cut will be less, so it feels sharper. If the blade of a large-sized one is made thin, it is easy to cause the blade to break due to excessive force in actual operation. For durability, the blade of large-sized punches is usually made thick. In addition, the leather area to be cut is larger, so the large-sized one will feel duller. Please use more force to knock. If the force is small, you need to knock two or three times more.

3. Equipment recommendation: According to the principle of mechanics, knocking on the thin desk will cause a greater rebound and will remove the force of the knock. Therefore, it is recommended that the workbench should be a more than 4cm thick solid wooden table or marble board, and then the punch board should be added for knocking. Do not put any soft and elastic materials such as felt, sheepskin, etc., under the pad. When using a hammer, hold the hammer close to the head. If the force is not well controlled and it cannot be penetrated at one time, please knock more than 2 times.

4. Each product surfaces are coated little rust preventive oil after production. Please wipe clean before use. When you no longer use the punch tool, apply some oil to the surface and place it in a dry and ventilated place. This will better protect the tool.

High-Temperature Treatment Process

To increase the hardness & anti-rust ability.

If the leather doesn't penetrate, keep hitting until it penetrates. The size is more than 5*10mm, because the cutting area is relatively large, it needs to be tapped a few more times.